Jetta III L4-1.9L DSL Turbo (AAZ) (1993)
9
Drive Plate
10 Bolt
11
Intermediate Plate
12
Sealing Flange With Oil Seal
13
Front Crankshaft Oil Seal
14
Auxiliary Shaft
15
O-ring
16
Sealing Flange For Auxiliary Shaft
NOTE: During removal and installation procedures, refer to the component location illustration above and component notes below.
COMPONENT NOTES
Auxiliary Shaft Oil Seal (1)
-
Remove to remove sealing flange.
-
Install using installer tool No. 10-203, or equivalent.
-
Lightly oil sealing lip, do NOT use grease.
Woodruff Key (2)
-
Ensure tight fit.
Bolt (3)
-
Tighten to: 25 Nm (18 ft. lbs.).
Gasket (5)
-
Always replace.
Bolt (7)
-
Tighten in two stages:
-
First stage, tighten to: 60 Nm (44 ft. lbs.).
-
Second stage, turn an additional: 90° (1/4 turn).
Washer (8)
-
Note installed position.
Drive Plate (9)
-
Use counter holder tool No. 3067, or equivalent to remove and install.
-
Refer to Transmission and Drivetrain.
Bolt 10)
-
Tighten to: 10 Nm (7 ft. lbs.).
Intermediate Plate (11)
-
Must be located on dowels.
-
Do not damage/bend when assembling.
Rear Crankshaft Oil Seal Flange (12)
-
Only replace complete.
-
Lightly oil sealing lip of oil seal, do NOT grease.
Rear Crankshaft Oil Seal (13)
-
Only replace with seal flange -11-.
O-ring (15)
-
Replace if damaged.
REMOVAL
1. Remove ribbed drive belt.
2. Remove toothed timing belt.
3. Remove crankshaft sprocket by counter-holding the sprocket with tool No. 3099, or equivalent.