Jetta III L4-1.9L DSL Turbo (AAZ) (1993)
Suspension/Steering/Steering Column/Service and Repair/Steering Column Tube & Steering Wheel, Servicing
14. -
Ignition/starter switch -D-
-
To remove, first remove steering lock housing, then remove securing screws
15. -
Lock cylinder
-
Removing/installing, Fig. 5
16. -
Spring
17. -
Clamping washer
Fig. 1 Horn pad, removing
WARNING! Vehicles with airbags, refer to Service Precautions See: Steering and Suspension/Steering/Steering Column/Service Precautions
Vehicles without airbag
-
Lift horn pad at bottom and pull from steering wheel in direction of arrow.
-
Remove horn wire.
Fig. 2 Horn plate, removing
-
Remove wire connector from horn plate.
-
Disengage retaining lugs -arrows- and remove contact plate -A- from contact plate -B-.
Note: The horn plate consists of two non insulated contact plates. Horn operates when the horn pad is pressed and plate -A- contacts plate -B- .
Fig. 3 Horn contact ring
The battery positive voltage (B+) for horn operation is supplied via a spring contact on the turn signal switch and a contact (slip) ring -arrow- under
the steering wheel.