Jetta III L4-1.9L DSL Turbo (AAZ) (1993)
Fig. 5 - Wheel Bearing, Pressing Out Of Wheel Bearing Housing
Fig. 6 - Lubricating inner surface of wheel bearing housing
-
Coat completely with MoS2 grease.
Fig. 7 - Wheel Bearing, Pressing Into Wheel Bearing Housing
Fig. 8 - Wheel Hub, Pressing Into Wheel Bearing
Replacement (Complete)
Front
NOTE:
-
From m.y. 1995 the suspension strut for vehicles with Plus suspension (6 cyl.) is also installed in vehicles with Base suspension (4 cyl.).
-
For this procedure, use the tools shown in the following illustrations or their equivalents.
-
Directly below the component legend are the Fig. numbers. Please refer to these for information regarding removal and installation instructions.