Jetta III L4-2.0L (ABA) (1995)
Oil Cooler: Service and Repair
NOTE: During removal and installation procedures, refer to the component location illustration and component notes.
CAUTION
‹› If large amounts of metal shavings or small metal particles are found in the engine oil, caused by wear of crankshaft and connecting rod bearings,
thoroughly clean the oil passages to remove contaminants and help prevent later damage.
‹› The oil cooler cannot be sufficiently cleaned, and must be replaced.
Lubrication system, components
10- Oil filter bracket
11- O-ring
‹› Always replace
12- Oil cooler
‹› On flange side coat contact surfaces outside seal with AMV 188 100 02
‹› Ensure clearance to surrounding components
CAUTION
Part numbers are listed here for reference only. Always check with your Parts department for the latest information.
13- 25 Nm (18 ft lb)
14- Oil filter
‹› Loosen with filter wrench
‹› Tighten by hand
‹› Note installation instructions on filter