Jetta III L4-2.0L (ABA) (1995)
Fluid Pump: Service and Repair
Disassemble/Assemble
01M Transmission
COMPONENT NOTES AND INFORMATION
1
Piston ring
-
Check that it is correctly located
-
Installing, refer to Fig. 2, below.
2
Piston ring
-
Check that it is correctly located
-
Installing, refer to Fig. 2, below.
3
Piston ring
-
Check that it is correctly located
-
Installing, refer to Fig. 2, below.
4
Thrust washer
5
Piston
-
Sealing lips are vulcanized to the piston
-
Moisten sealing lips with ATF before installing
-
Turn piston slightly when installing
6
Bolt
-
Tighten to: 10 Nm (7 ft lb) plus and additional 1/8 turn (45°)
7
Stator support
8
Outer gear
-
Manufacturer's marking (arrow) faces stator support
-
If outer gear is incorrectly installed, the ATF pump may not operate freely in the installed position
9
Inner gear
-
Larger groove faces stator support
10
Housing for ATF pump
11
O-ring
-
Always replace
12
Torque converter oil seal
-
Removing and installing, refer to Replacement. See: Seals and Gaskets/Service and Repair
PROCEDURES