Jetta III L4-2.0L (ABA) (1995)
-
Remove guard plate from between relay panel and pedal cluster as follows:
-
Remove electrical wires from retainers -arrow 1-.
-
Press snap detent -arrow 2- toward pedal cluster.
-
Press guard plate up toward instrument panel -arrow 3- until it can be removed from its retainers.
-
Remove guard plate from below, working carefully to avoid damage to wiring.
-
Insert screwdriver between steering column and clutch pedal and press it against over-center spring.
-
Depress clutch pedal and disconnect over-center spring from pedal in direction indicated by arrow.
INSTALLATION
-
Install spring in reverse order of removal, and note the following:
-
Install relay panel in left-hand side retainer before installing over-center spring.
-
Pull clutch pedal back into passenger compartment.
-
Guide over-center spring between pedal and relay panel holder until it is in bracket -arrow 1- while being pressed below clutch pedal support
-arrow 2-.
-
Press over-center spring onto pedal support, depressing clutch pedal slightly if necessary.
NOTE:
^
If clutch pedal operation is noisy (squeaks), lightly lubricate the spring contact points with lithium grease, refer to arrows -1- and -2- in
illustration above.
^
If the noise persists, also lubricate the internal sliding surfaces of the spring.