Jetta III L4-2.0L (ABA) (1995)
-
Dimension -a- = 541 ± 1 mm (21.30 ± 0.04 in.) for the following engine:
^
1.8L 66 kW (90 hp)
^
1.9L 55 kW (75 hp) Turbo-Diesel
^
2.0L 85 kW (115 hp)
-
Dimension -a- = 521 ± 1 mm (20.67 ± 0.04 in.) for the following engine:
^
1.9L 66 kW (90 hp) TDI
Fig. 2 - Outer Constant Velocity Joint, Removing
-
Drive joint off axle shaft with firm blow from soft mallet.
Fig. 3 - Inner Constant Velocity Joint, Pressing Off
-
First use drift to drive off boot.
-
Support ball hub while pressing off.
Fig. 4 Inner Constant Velocity Joint, Pressing On
-
Press joint on up to stop.
-
Install circlip.
NOTE: Chamfer on inner diameter of ball hub (splices) must face the contact shoulder on the axle shaft.