Jetta III L4-2.0L (ABA) (1995)
-
Replace complete part only
-
Removing, Refer to Fig. 1
-
Installing: drive onto shaft with plastic hammer until circlip seats (springs into groove)
2- Circlip
-
Always replace
-
Insert in groove in shaft
3- Thrust ring
4- Belleville spring
-
Larger diameter (concave side) contacts with thrust ring
5- Clamp
-
Always replace
6- Boot
-
Check for tears and chafing
7- Clamp
8- Axle shaft
9- Clamp
-
For triple-rotor joint
10- Boot
11- Clamp
-
For triple-rotor joint
12- Cover
-
Destroyed when disassembling
-
No longer required for assembly; not available as replacement part
13- Rectangular sealing ring
-
Included in repair kit; not used in production
14- O-ring
-
Not required for assembly
15- Circlip
16- Roller
17- Triple-rotor star
-
Chamfer -arrow- goes onto axle shaft splines first
18- Multi-point socket-head bolt
-
M10 x 20
-
Tighten to: 80 Nm 159 ft. lb.)
19- Housing