Jetta III L4-2.0L (ABA) (1995)
-
Remove nuts attaching gearshift housing to center console -arrows-.
-
Remove Three Way Catalytic Converter (TWC), refer to Exhaust System
-
Remove shield at front, push toward the rear, then pull out toward front.
-
Remove clamp for selector rod/selector lever at front -arrow 1-, and remove front bolt -arrow 2- attaching bracket to steering gear.
-
Remove bracket from steering gear -arrows-.
-
Remove gearshift housing from body.
-
Press transmission housing toward rear, press up on selector rod with bracket and selector lever inch engine compartment.
-
Remove and selector lever from selector rod.
-
Swivel down transmission housing with selector rod, -arrow 1- while pressing toward engine -arrow 2- and remove.
INSTALLATION
-
Install inch reverse order of removal.
-
Tighten as shown in Component Notes And Information above.
-
Adjust shift linkage. See: Shift Linkage/Adjustments
-
Installing shift lever boot refer to "Shift Lever and Shift Lever Boot". See: Shift Lever and Shift Lever Boot