Jetta III L4-2.0L (ABA) (1995)
Wiper Blade: Adjustments
Wiper Blade Contact Angle
Checking Contact Angle:
-
Bring wiper arm to rest position.
-
Remove wiper blade.
-
Place wiper arm -2- in wiper arm adjusting tool 3358 and secure with retaining screw -3-.
-
Compare angle indicated with specification below:
Driver side (Wiper blade with plastic spoiler) 0 °
Driver side
- 3 °
Passenger side
0 °
Rear window wiper
+ 3 °
Tolerance
± 2 °
Adjusting Wiper Arm:
-
Use 24 mm open end wrench -1- on wiper arm adjusting tool 3358 and twist wiper arm -2- in direction of arrows until setting matches
specification above.
-
Loosen retaining screw -3- and remove wiper arm adjusting tool 3358 from wiper arm -2- then reinstall and recheck.
-
Compare angle indicated with specification above.
-
If necessary, repeat setting and checking procedure until specification is met.
-
Remove adjusting tool and re-install wiper blade.