Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
Yaw Rate Sensor: Service and Repair
ESP Sensor Unit -G419-, Removing and Installing
ESP sensor unit -G419-, vehicles from my 02.02, removing and installing
The Sensor for transverse acceleration -G200-, the Sender for rotation rate -G202- and the Longitudinal acceleration sensor1) -G251- are assembled
together in one housing on a new bracket, at the same place in the vehicle.
1) 4Motion vehicles with Haldex clutch only
-
The ESP-sensor unit -G419- -1- is secured with a bracket on the steering column bearing bracket -a-.
When the ESP-sensor unit -G419- is replaced, a zero compensation of the sensor for transverse acceleration -G200-, the sender for rotation rate
-G202, and the longitudinal acceleration sensor1) -G251- must be performed.
1) 4Motion vehicles with Haldex clutch only
Removing
-
Disconnect connector (arrow) from ESP-sensor unit -G419-
-
Remove bolt -1- and remove ESP-sensor unit -G419-
-
Remove nuts -a- from the ESP-sensor unit -G419-
-
Remove ESP-sensor unit -G419-
CAUTION! Sharp shaking motions can destroy the Sensor for transverse acceleration - G200-, Sender for Rotation Rate -G202- and