Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
Brake Master Cylinder: Service and Repair
Brake Master Cylinder, Removing and Installing
Brake master cylinder, removing and installing
Special tools and equipment
^
3094 Hose clamps
Removing
-
Obtain radio code on vehicles with coded radio.
-
Disconnect battery.
-
Lay out sufficient lint free clothes in area of plenum chamber, engine and transmission.
-
Draw off as much brake fluid as possible from brake fluid reservoir using brake filler and bleeder unit VAS 5234.
-
Clamp clutch master cylinder supply hose with special tool 3094.
-
Disconnect clutch master cylinder supply hose.
-
Disconnect connector off float warning indicator sensor.
Vehicles with ABS/EDL/ASR/ESP
-
Disconnect connectors (arrows) off brake pressure sensors -a- and -b-.
Continued for all vehicles
-
Disconnect brake lines on brake master cylinder and seal brake lines with plugs from repair kit Part No. 1 H0 698 311 A.
-
Remove brake master cylinder nuts.
-
Remove heat shield, if part of original equipment.