Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
Acceleration/Deceleration Sensor: Service and Repair
Longitudinal acceleration sensor -G251-, removing and installing
The longitudinal acceleration sensor -G251- -1- is located on the right-hand A-pillar
Removing
-
Note or request radio code on vehicles with coded radio if necessary.
-
Disconnect battery.
-
Remove glove box.
-
Disconnect connector off longitudinal acceleration sensor -G251-.
-
Lift retainer -1- off longitudinal acceleration sensor -G251- -2- with a screwdriver.
Installing
CAUTION! Strong vibrations can damage longitudinal acceleration sensor -G251-.
-
Insert longitudinal acceleration sensor -G251- into retainer.
-
Installation position: The angled section (arrow) of longitudinal acceleration sensor - G251- -1- must face retainer -2-.
-
Slide retainer -2- over longitudinal acceleration sensor -G251- -1- until it engages.
Further installation in reverse order.