Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
-
Check wires between test box and 8-pin connector to Transmission Control Module (TCM) for open circuit according to wiring diagram.
Terminal 2 + socket 40
Terminal 3 + socket 68 and 45
Terminal 4 + socket 41
Terminal 5 + socket 18
Terminal 6 + socket 1 and 24
Terminal 7 + socket 19
Wire resistance: max. 1.5 Ohms
Continue for all vehicles
-
Check wires for short circuit to each other.
Specified value: Infinite Ohms
If no malfunctions are found in wires:
Vehicles with 01M transmission
-
Check adjustment of selector lever cable
Vehicles with 09A transmission
-
Check adjustment of selector lever cable
Continue for all vehicles
-
Erase DTC memory of Transmission Control Module (TCM), Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan
Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If no malfunctions are detected in the wires and the selector lever cable adjustment is OK:
-
Replace Multi-Function Transmission Range (TR) Switch -F125-.
-
Erase DTC memory of Transmission Control Module (TCM), Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan
Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes