Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
/Page-1430007.png)
-
If the tandem pump has a black steel cover -A- with a part number 038 145 209 F, the manufacturer is LUK
-
Check the tandem pump housing for a green mark at either location -G-
-
If there is a green mark, no further work is required, close hood
-
If there is no green mark, proceed to Section B for Golf and Jetta vehicles, Section D for Passat vehicles or Section F for New Beetle
vehicles
Section B
Section B - Golf and Jetta Tandem Pump Removal
-
Use special spring clamp pliers V.A.G 1921 to remove flexible air hose between mass air flow sensor and air pipe
-
If vehicle has glow plugs for coolant heating, remove connector from center glow plug
WARNING:
-
The fuel and the fuel lines in the fuel system can become very hot. The fuel system is also under pressure
-
Before opening the system, place cloths around the connection and carefully loosen connection to release the pressure
-
Wear hand and eye protection when performing any type of repair work on the fuel system
-
Use special spring clamp pliers VAS 5024A to remove clamp and fuel supply hose -1- with white mark and clamp and fuel return hose -2- with
blue mark from fuel filter
-
Connect suction pump VAS 5226 to fuel return hose -2-
-
Operate suction pump until no more fuel comes out of fuel return hose
