Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
/Page-1643003.png)
^
After glow plugs and glow plug control module have been installed, continue to Section C - Engine Control Module Update - Programming
(Flashing) using Software Version Management (SVM)
Section B - Passat/Passat Wagon:
Installing New Glow Plugs, and Engine Control Module Update - Programming (Flashing) using Software Version Management (SVM).
Note
Tip:
Hard / no start conditions above freezing temperatures are not related to this issue.
Step 1:
^
Install glow plugs from table below. Refer to direction in Elsaweb»Re pair Manual >> Engine >> Engine Mechanical, Fuel Injection and Glow Plug
>> 28 Ignition/Glow Plug System >> Removal and Installation.
Step 2:
^
After glow plugs have been installed, continue to Section C - Engine Control Module Update - Programming (Flashing) using Software Version
Management (SVM)
Section C - Engine Control Module Update - Programming (Flashing) using Software Version Management (SVM):
Engine Control Module Update - Programming (Flashing) using Software Version Management (SVM)
Tip:
Note:
