Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
/Page-2720002.png)
^
Carefully separate connectors from harness to side airbag igniter -N199- (driver seat) and -N200- (passenger seat).
Tip:
The pictures are used to illustrate connector location only, seat does not have to be disassembled for repair.
Rabbit/new GTI/Eos ONLY:
^
Remove male and female side connectors T3K (N199-drivers side), T3L (N200 passenger side, as shown) by cutting one wire at a time, discard
connectors.
Jetta ONLY:
^
Remove male and female side connectors T3aa, T3ab (as shown) by cutting one wire at a time, discard connectors.
Passat ONLY:
^
Remove male and female side connectors T3 (N199-drivers side), T3a (N200-pass. side, as shown) by cutting one wire at a time discard connectors.
^
Using butt splice crimping tool VAS 1978/24: Splice the harness together using three 4 in. sections of Repair wire Part No: 000 979 010 (from VAS
1978AR wiring repair kit) and 6 butt connectors Part No: 111 971 941A harness repair kit 1978.
The 4 in. sections of repair wire allow additional wiring harness maneuverability.
^
Check the connectors from the airbag harness to the body harness for proper connection on both seats.
^
Wrap all repaired wires using yellow electrical tape to indicate that the wiring has been modified.
