Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
Yaw Rate Sensor: Service and Repair
Sender For Rotation Rate -G202- and Sensor For Transverse Acceleration - G200-, Removing and
Installing
Sender for rotation rate -G202- and sensor for transverse acceleration - G200-, removing and installing
Note: The removal and installation sequence for the sender for rotation rate -G202- and the sensor for transverse acceleration -G200- is identical
except for the mounting bracket for each component.
Removing
-
Request radio code on vehicles with coded radio if necessary.
-
Disconnect battery.
-
Remove Qty. 2 screws -1-.
-
Unclip top of trim -2-
-
Remove Qty. 2 screws -3-
-
Unclip top of trim -4-.
-
Remove Qty. 7 screws (arrows).
-
Take off reinforcement -1-.
-
The sender for rotation rate -G202- -1- and the sensor for transverse acceleration - G200- -2- are located on the steering column -3- bearing
bracket.
a - Steering column