Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
/Page-513003.png)
-
Remove mounting bolt and remove sensor -1- from transmission.
-
Disconnect harness connector from Vehicle Speed Sensor (VSS) -G68-.
Installation is performed in reverse order of removal.
-
Replace O-ring.
-
Install sensor and tighten to 10 Nm.
Tightening torques of transmission holder and of pendulum support:
-
Erase DTC memory of Transmission Control Module (TCM), Diagnostic mode 4: Reset/erase diagnostic data. See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic
Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and
Readiness Codes
