Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
Transmission Speed Sensor: Testing and Inspection
Intermediate Shaft Speed Sensor, Checking
Intermediate Shaft Speed Sensor, Checking (vehicles With 09A Transmission)
NOTE: Sensor is located inside the transmission and is not accessible from the outside.
Recommended special tools and equipment
-
V.A.G 1526 multimeter or V.A.G 1715 multimeter
-
V.A.G 1594 connector test kit
-
Wiring diagram
Requirements
-
Respective fuses must be OK:
-
Selector lever must be in -P- position.
-
All electrical consumers such as, lights and rear window defroster must be switched off.
-
Parking brake must be engaged.
-
Ground (GND) connections to transmission must be OK.
-
Ignition switched off.
Test sequence
-
Disconnect 20-pin harness connector -2-.
Observe safety precautions.
-
Check harness connector for contact corrosion and ingress of water.
If harness connector is not OK:
-
Repair malfunction.
-
Erase DTC memory of Transmission Control Module (TCM), Diagnostic mode 4: Reset/erase diagnostic data. See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic
Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and
Readiness Codes
If harness connector is OK:
-
Check wires to Transmission Control Module (TCM) according to wiring diagram.
Checking wires to Transmission Control Module (TCM)
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/Test Box, Connecting For Wiring Test