Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
Battery terminal -1- and additional terminal -2- tightening torques.
Battery, Charging
Battery, Charging
WARNING: Prior to handling or servicing batteries, read, understand and observe the Warning and Safety measures for lead-acid batteries.
Battery Charger, Connecting
Battery Charger, Connecting
WARNING:
Danger of explosion.
-
Batteries produce explosive gasses while being charged.
-
Keep open flames and sparks away and DO NOT smoke near batteries.
-
The battery charger MUST be turned off when connecting or disconnecting the cables at the battery.
-
Battery cell caps must NOT be removed while charging.
-
"Boosting" a sulfated battery a high charging rate can cause an explosion.
-
Ensure that battery is charged in a well ventilated area.
-
Precision tools must not be kept in the same room where batteries are being charged. Tools may corrode due to chemical reaction.
CAUTION: In order to prevent damage to the battery or vehicle, observe battery type descriptions and notes.
Special tools and auxiliary items needed
-
Battery Charging Station: Midtronics INC-940
NOTE:
-
Before charging, battery must have a minimum temperature of 10 degrees C (50 degrees F)
-
It is not necessary to remove battery from vehicle or disconnect battery terminals.
-
Charging voltage must not exceed 14.4 V.
-
Always follow the battery charger operating instructions
-
After charging, confirm battery no load voltage and electrolyte specific gravity before reuse in vehicle.
CAUTION: Before beginning repairs on the electrical system
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Connect battery charger to battery, positive to positive (+), negative to negative (-).
-
Switch on battery charger.
-
Adjust charging rate according to battery capacity (refer to charger instructions).
WARNING: If battery begins gassing (boiling) violently when charging, REDUCE charging rate immediately.
Charging Totally Discharged Batteries
Charging Totally Discharged Batteries