Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
Special tools and auxiliary items needed
-
VAG 1331 Torque wrench (or equivalent 5 - 50 Nm)
NOTE:
-
In order to prevent damage to the battery housing, battery terminals must be placed on battery posts without using force (by hand only).
-
Battery posts and terminals must no longer be greased.
-
Refit battery positive ( B+ ) terminal on battery positive post.
-
Torque positive ( B+ ) terminal clamp fastener to 6 Nm.
-
Fit fuse holder onto battery and install positive bus onto securing pins on battery positive terminal.
-
Engage fuse holder clip in battery.
-
Tighten securing bolt -1- for positive bus on positive ( + ) terminal clamp.
-
Connect cables to strip fuses and tighten securing bolts -A-.
NOTE: Refer to appropriate wiring diagram for installed positions of cables to fuses if necessary.
-
Refit electrical connection -2-.
-
Only after the fuse holder and positive ( B+ )terminal have been secured should the negative ( - ) terminal clamp be installed.
-
Torque negative ( - ) terminal clamp fastener to 6 Nm.
-
If necessary, reinstall cover -1- with screws -arrows-.
-
Perform work steps specified in table.
Battery With Clipped Fuse Holder, Disconnecting and Reconnecting