Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
Ignition Switch Lock Cylinder: Service and Repair
Lock Cylinder, Removing And Installing
CAUTION:
Before beginning repairs on the electrical system:
-
Obtain the anti-theft radio security code.
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Disconnect negative ( - ) battery terminal.
-
When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on
performing OBD program and electrical system function checks
Removing
-
Disconnect battery.
-
Remove steering column switches.
-
Where applicable, carefully disconnect electrical connection for the induction coil for anti-theft immobilizer from lock cylinder.
NOTE: If equipped, the induction coil for anti-theft immobilizer is integrated with the lock cylinder and cannot be serviced separately.
-
Insert ignition key in lock cylinder and turn to position "Drive".
Position of key in lock cylinder:
1. Position "Stop"
2. Position "Drive"
3. Position "Start"
-
Insert steel wire (approx. dia. 1.2 mm) in drilling next to ignition key -arrow-.
NOTE: To enable steel wire to be inserted straight into hole, ignition key may have to be dismantled and inserted into lock cylinder without key