Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
-
Press gear selector cable onto transmission selector lever and gate selector cable onto relay lever (arrows).
Selector mechanism from 01.01
The cable locks have holes for securing them on the gear selector lever or the relay lever.
The holes in the cable locks have various diameters.
Allocation
The cable locks no longer need to be replaced following disassembling.
-
Spread a small quantity of polyurea grease on pins (arrows) of gear change lever -1- and relay lever -2-.
Note: Always replace securing clips -3- and -4- after disassembling.
-
Secure gear selector cable with securing clip -3- and gate selector cable with securing clip -4-.
Continued for all selector mechanisms
-
Align gear lever housing parallel to body.
^
Distance to body must be same on both sides.