Jetta Sedan L4-2.0L (BBW) (2005)
9 - Bolt
^
5 Nm
^
Tighten two centering bolts (arrow) first by hand
10 - Gasket
^
Always replace
^
Insert in valve body
11 - Valve body
^
Removing go to Fig. 4
^
Installing go to Fig. 9
^
Marking go to Fig. 6
^
Installing seal item -10-
12 - Bolt
^
10 Nm
13 - O-ring
^
For cable transition piece
^
Always replace
14 - Conductor strip
^
With cable transition piece and connector
^
Can be removed and installed with transmission installed
15 - Retaining bracket
^
For conductor strip connector, installing go to Fig. 11
16 - Bolt
^
20 Nm
17 - Plug for solenoid valves
^
Pull off solenoid valves with 3373 go to Fig. 3
18 - Sealing plug
^
Take out before removing and installing freewheel
^
Insert so that tab is located in groove on housing go to Fig. 5
^
Place O-rings onto sealing plug
19 - O-ring
^
Always replace
20 - O-ring
^
Always replace
21 - Operating rod for manual selector valve
^
Unhooking go to Fig. 4
^
Install with stepped side facing manual selector valve go to Fig. 7
^
Adjusting go to Fig. 8
Fig. 1 Draining ATF
-
Place container under transmission.