Jetta Sedan L5-2.5L (BGP) (2005)
Rear Door Hinge: Locations
Door Hinges - Assembly Overview
CAUTION: The nut for eccentric pin - 9 - must not be loosened under any circumstances. It cannot be secured again using workshop equipment.
NOTE:
-
The description applies to the right side. The left side is derived accordingly from this.
-
Bolts for door hinges must always be replaced after loosening.
-
Hinges are no longer manufactured as separated parts.
1. Door
-
Adjusting
2. Guide bolt
-
10 Nm
3. Door hinge with door arrester
4. Socket-head bolt
-
20 Nm + 1 4 additional turn (90 degrees)
-
Always replace bolt after loosening
5. Socket-head bolt
-
20 Nm + 1 4 additional turn (90 degrees)
-
Always replace bolt after loosening
6. Socket-head bolt
-
20 Nm + 1 4 additional turn (90 degrees)
-
Always replace bolt after loosening
7. Socket-head bolt
-
20 Nm + 1 4 additional turn (90 degrees)
-
Always replace bolt after loosening
8. Guide bolt
-
10 Nm
9. Nut