Jetta Sedan L5-2.5L (BGP) (2005)
Clutch Switch: Testing and Inspection
Clutch Position Sensor G476, Checking Signal
Special tools, testers and auxiliary items required
-
Hand multimeter V.A.G 1526 or Multimeter V.A.G 1715
-
Connector test set V.A.G 1594
-
Wiring diagram
Test conditions
-
The respective fuse of Clutch Position Sensor G476 must be OK.
-
Battery voltage must be at least 11.5 Volts.
-
All electrical consumers such as, lights and rear window defroster must be switched off.
-
The parking brake must be applied, otherwise daytime running lights are switched on.
-
If vehicle is equipped with an A/C system, it must be switched off.
-
The ground (GND) connections between engine and body must be OK.
-
Ignition switched off.
Test sequence
-
Remove engine cover.
-
Remove battery and battery carrier.
-
Disconnect the 5-pin connector - 4 - of Clutch Position Sensor G476.
-
Check wiring from terminal 5 to fuse SB 7 in engine compartment E-Box and the fuse itself.
-
Connect test box to Motronic Engine Control Module (ECM) J220 wiring harness. See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/Test Box, Connecting For Wiring Test
-
Check wiring between test box and 5-pin connector for open circuit according to wiring diagram.
Contact
Test box socket
2
39