Jetta Sedan L5-2.5L (BGP) (2005)
-
Disconnect harness connector of sensor wire at Power Steering Control Module J500.
-
To do so, press button - A - in direction of - arrow - and then disconnect connector.
-
Unscrew mounting bolts - 1 - and remove servo motor with control module from steering gear housing.
Note:
^
When unscrewing bolts, secure servo motor with control module from falling down (with second mechanic if necessary).
^
If corrosion, damage, wear-out or first signs of soiling on steering rack can be seen, complete steering gear must be replaced.
^
If no grease film is visible on steering rack, steering gear must also be replaced completely.
^
The steering gear housing has 3 or 4 bores and also servo motors with 3 or 4 threads. Note the corresponding threaded connection. Three threaded
connections are permitted when only 3 threaded connections are possible in a steering gear housing or in a servo motor.
Installing
-
Pull a new sealing ring on to servo motor with control module.
Before installing, pinion and new sealing ring for servo motor must be coated with grease G 052 192 A1 supplied in the repair set.
CAUTION: Do not use other grease under any circumstances.
-
Insert servo motor with control module into steering gear housing and tighten in diagonal sequence with new bolts - 1 -.
-
Connect harness connector of sensor wire to Power Steering Control Module J500.
Connector must engage audibly.
-
Install new hydraulic thrust piece.
Replacement part set contains a new hydraulic thrust piece among other items.