Jetta Sedan L5-2.5L (BGP) (2005)
Specified value: 1.5 ohms Max.
If the specification was not obtained:
-
Check the wiring for an open circuit, short circuit to each other, Battery (+), and Ground (GND).
-
If necessary, repair the faulty wiring connection.
If no malfunction was found in the wiring and the resistance was not OK:
-
Replace the Multi-Function Transmission Range (TR) Switch (F125).
-
Erase the DTC memory. Refer to --> [ Diagnostic Mode 04 - Erase DTC Memory ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Diagnostic Mode 04 - Erase DTC Memory.
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. Refer to --> [ Readiness Code ] See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/Readiness Code.
-
End of diagnosis.
If the DTC does return and no malfunction is detected in the wiring and resistance was OK:
-
Replace the Transmission Control Module (TCM) (J217)
-
Assembly is performed in the reverse of the removal.
Final procedures
1. Check the DTC memory. Refer to --> [ Diagnostic Mode 03 - Read DTC Memory ] See: Powertrain Management/Computers and Control
Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Diagnostic Mode 03 - Read DTC Memory.