Jetta Sedan L5-2.5L (CBTA) (2009)
Cowl Moulding / Trim: Service and Repair
Plenum Chamber Cover
Flush Bonded Windows
Plenum Chamber Cover
Remove
-
Remove wiper arms.
CAUTION!
Plenum chamber cover must not be pried off using any tool. Window will be damaged and may crack later.
-
Pull off seal of plenum chamber - 4 - on the entire length of facing wall - 2 - of plenum chamber.
-
Pull out plenum chamber cover - 1 - starting at right carefully upward from binding profile - 5 -.
Installing
CAUTION!
Striking the plenum chamber cover can cause cracks in the windshield.
-
Spray binding profile - 5 - with soap solution so that plenum chamber cover - 1 - can be pressed in more easily.
-
Place plenum chamber cover - 1 - onto binding profile - 5 - and engage it with binding profile - 5 - starting from center using light pressure.
-
Install plenum chamber seal - 4 - and windshield wipers.
‹› In new windshields, an insert is installed in the binding profile. This insert must be removed before installing the plenum chamber cover.