Jetta Sedan L5-2.5L (CBTA) (2009)
/Page-821005.png)
‹› The brake line must contact the stop when the screws are tightened, otherwise the flared head will not be formed correctly.
-
Clamp the brake line in the (VAS 6056/1) until it cannot be moved any more. Fold the stop - A - up and tighten the screws diagonally with the AF
6 angle head driver - C -.
-
Turn the spindle to stop in the (VAS 6056/1).
-
Turn the spindle back.
-
Loosen the screws diagonally.
-
Remove the brake line from the (VAS 6056/1), clean and check the brake line and the flared head.
Briefly rinse part of the brake line remaining in vehicle.
-
Connect the (VAS 5234), place the bleeder container hose on the flanged head of the brake line and run the (VAS 5234) briefly until some brake
fluid runs through.
-
Blow out the brake line to be inserted with compressed air.
-
Join the brake lines with a connecting piece - E -.
