Jetta Sedan L5-2.5L (CBTA) (2009)
-
Place the guide frame on a soft surface.
-
Insert the camshafts correctly into the guide frame.
‹› Intake camshaft with sensor wheel - 2 - points toward the Camshaft Position (CMP) sensor - 1 -.
‹› Camshafts must lie exactly in the axial bearings - 3 - of the guide frame.
‹› Sealing ring ends - 4 - and - 5 - must point upward or downward, they must not point to the side under any circumstances.
-
Turn around the guide frame with the camshafts installed slightly, hold the camshafts firmly in place in the guide frame while doing this.
-
Rotate the camshafts until the threaded holes - arrows - point upward.
-
Check whether the camshafts still lie exactly in the axial bearings of the guide frame.
-
Install the (T40070) as shown onto the camshafts and tighten the bolts to 20 Nm.