Jetta Sedan L5-2.5L (CBTA) (2009)
‹› Removing and installing, refer to --> [ Front Exhaust Pipe with Catalytic Converter ] See: Front Exhaust Pipe with Catalytic Converter.
‹› Install exhaust system free of stress, refer to --> [ Exhaust System, Installing ] See: Service and Repair/Exhaust System, Installing.
5
Clamp
‹› Before tightening, ensure exhaust system is free of tension, refer to --> [ Exhaust System, Installing ] See: Service and Repair/Exhaust System,
Installing.
‹› Installed location, refer to --> [ Installed Position of Clamp ]
‹› Tighten the bolts evenly.
6
Nut, 25 Nm
7
Nut, 23 Nm
8
Front crossmember
9
Oxygen Sensor (O2S) behind Three Way Catalytic Converter (TWC) (G130), 55 Nm
‹› Only use hot bolt paste (G 052 118 A3) to grease the threads; do not let the hot bolt paste (G 052 118 A3) get onto the slits of the sensor body.
10
Connector
‹› Brown, 4 pin.
‹› Installed location, refer to --> [ Installed Position Harness Connector for Oxygen Sensor ]
11
Bolt, 25 Nm
12
Suspended mount
‹› Replace if damaged.
Installed Position of Clamp
- Arrow - points in direction of vehicle travel.
-
Align the clamp - 1 - to the marking on catalytic converter - 2 -.
- a -= 5 mm
Bolts must not project beyond the lower edge of the clamp.
Installed Position Harness Connector for Oxygen Sensor