Jetta Sedan L5-2.5L (CBTA) (2009)
9
Coolant pump
‹› In the cylinder block.
‹› Removing and installing, refer to --> [ Coolant Pump ] See: Engine, Cooling and Exhaust/Cooling System/Water Pump/Service and Repair.
10
Ribbed belt, for generator and coolant pump
‹› Ribbed belt routing, refer to --> [ Ribbed Belt Routing ]
‹› Before removing, mark direction of rotation using chalk or a felt tip marker.
‹› Check for wear.
‹› Do not kink.
‹› Removing and installing, refer to --> [ Ribbed Belt ] See: Ribbed Belt.
11
Ribbed belt, for A/C compressor
‹› Ribbed belt routing, refer to --> [ Ribbed Belt Routing ]
‹› Before removing, mark direction of rotation using a chalk or felt tip marker.
‹› Check for wear.
‹› Do not kink.
‹› Removing and installing, refer to --> [ Ribbed Belt ] See: Ribbed Belt.
12
Crankshaft pulley/vibration damper
‹› Multiple versions.
‹› To remove and install, secure the crankshaft. Refer to --> [ Crankshaft, Locking ] See: Engine, Cooling and Exhaust/Engine/Cylinder Block
Assembly/Crankshaft/Service and Repair/Procedures/Crankshaft, Locking.
13
Bolt
‹› Quantity: 5
‹› Always replace.
‹› Only use strength category 10.9.
‹› 50 Nm + 90° (1/4 turn) additional turn.
14
Bushing
‹› Quantity: 2
15
Belt tensioner, A/C compressor ribbed belt, 35 Nm
‹› Do not remove the tensioner wheel from the tensioner.
16
Belt tensioner, generator and coolant pump ribbed belt, 35 Nm
‹› Do not remove the tensioner wheel from the tensioner.
17
Bolt, 25 Nm
18
Bolt, 8 Nm
19
Idler pulley, with bracket