Jetta Sedan L5-2.5L (CBTA) (2009)
Repair.
-
Press connector lock - 1 - toward rear - arrow - and disconnect connector - 2 - from crash sensor - 4 -.
-
Remove the two bolts - 3 - (9 Nm) and the crash sensor - 4 -.
Installing
To install, perform the steps used for removal in reverse order.
-
Switch on ignition.
CAUTION!
Make sure that no persons are in the vehicle.
-
Connect vehicle battery..
Rear Wheelhousing Crash Sensors, Wagon
‹› Removal and installation is described for the left-hand side of the vehicle. Removal and installation for the right-hand side is performed in the
same manner.
Removing
CAUTION!
Observe safety precautions for working on airbags.
-
Disconnect vehicle battery.
-
Fold the bench seat and backrest forward.
-
Remove side upholstery:
‹› with rear side airbags, refer to --> [ Side Upholstery with Side Airbag ] See: Body and Frame/Seats/Service and Repair/Rear Seats.
‹› without rear side airbags, refer to --> [ Side Upholstery without Side Airbag ] See: Body and Frame/Seats/Service and Repair/Rear Seats.
-
Remove wheelhousing trim. Refer to --> [ Wheel Housing Trim, Wagon ] See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and
Repair.