Jetta Sedan L5-2.5L (CBTA) (2009)
Ride Height Sensor: Service and Repair
Rear Suspension
Rear Level Control System Sensor
Rear Level Control System Sensor
Special tools, testers and auxiliary items required
‹› Torque wrench (VAG 1410)
Removing
-
Disconnect electrical connector - 1 -.
-
Remove the bolts - 2 - from the lower transverse link.
-
Remove bolts - arrows - from the subframe.
-
Remove the left rear level control system sensor.
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
The left rear level control system sensor lever must point toward the outside of the vehicle.
-
After replacing, perform a headlamp basic setting. Refer to --> Vehicle Diagnosis, Testing, and Information System VAS 5051 in "Guided Fault
Finding" function.
Tightening Specifications
Rear Level Control System Sensor Assembly Overview
Rear Level Control System Sensor Assembly Overview
‹› The rear level control system sensor is available as replacement part only complete with coupling rod and upper and lower retaining plates.
‹› Replacing with the subframe installed. refer to --> [ Rear Level Control System Sensor ] See: Rear Level Control System Sensor.
‹› With headlamp range control module.