Jetta Sedan L5-2.5L (CBTA) (2009)
‹› Always replace after removal.
‹› Always tighten threaded connections in curb weight position. Refer to --> [ Wheel Bearing Housing, Lifting to Curb Weight Position ] See:
Service and Repair/Rear Suspension/Wheel Bearing Housing, Lifting to Curb Weight Position.
15
Washer
16
Nut, 130 Nm + 90° additional turn
‹› M14 x 1.5.
‹› Self locking.
‹› Always replace after removal.
‹› Always tighten threaded connections in curb weight position. Refer to --> [ Wheel Bearing Housing, Lifting to Curb Weight Position ] See:
Service and Repair/Rear Suspension/Wheel Bearing Housing, Lifting to Curb Weight Position.
17
Wheel bearing housing
‹› Removing and installing, refer to --> [ Wheel Bearing Housing ] See: Rear Knuckle/Service and Repair/Wheel Bearing Housing.
18
Washer
19
Bolt
‹› Always replace after removal.
‹› Always tighten threaded connections in curb weight position. Refer to --> [ Wheel Bearing Housing, Lifting to Curb Weight Position ] See:
Service and Repair/Rear Suspension/Wheel Bearing Housing, Lifting to Curb Weight Position.
20
Tie rod
‹› Closed in direction of travel.
21
Bolt
‹› Always replace after removal.
22
Nut, 90 Nm + 90° additional turn
‹› M12 x 1.5.
‹› Self locking.
‹› Always replace after removal.
‹› Always tighten threaded connections in curb weight position. Refer to --> [ Wheel Bearing Housing, Lifting to Curb Weight Position ] See:
Service and Repair/Rear Suspension/Wheel Bearing Housing, Lifting to Curb Weight Position.