Jetta Sedan L5-2.5L (CBTA) (2009)
6
Socket head cap screw, 20 Nm
7
Clutch release lever
‹› Remove and install together with release bearing --> [ Removing and installing release bearing ]
‹› Remove grease already present
8
Release bearing
‹› Do not wash-out bearing, only wipe off
‹› Replace noisy bearings
‹› Removing from clutch lever and inserting into clutch lever --> [ Removing and installing release bearing ]
‹› Lubricate contact surfaces of release lever with MoS2 grease
9
Collar bolt, 20 Nm
10
Clutch master cylinder
‹› Removing and installing --> [ Slave Cylinder ] See: Clutch Hydraulic System/Clutch Slave Cylinder/Service and Repair
11
Plunger
12
Assembly bolt
‹› Secures clutch release lever when installing transmission
‹› Remove after transmission has been installed
‹› If the assembly bolt --> [ 12 Assembly bolt ] is not equipped, a bolt M 8 x 35 can be used.
Removing and installing clutch release lever with release bearing
-
Unhook spring - arrow 1 -.
-
Pull off clutch release lever - arrow 2 - and release bearing.
-
Installation is in reverse order of removal.
Removing and installing release bearing