Jetta Sedan L5-2.5L (CBTA) (2009)
Shifter M/T: Procedures
Shift Mechanism Installation Position
- Arrow A - Gear movement
- Arrow B - Selection movement
A - Shift cable for gear movement
B - Selector cable for selector movement
C - Heat shield
‹› Remove before removing gear selector mechanism.
1 - Transmission shift lever
2 - Relay lever
‹› Note radio coding for vehicles with coded radio.
‹› When working on the shift mechanism in the engine compartment, disconnect the Ground (GND) cable from the battery
‹› If battery is re-connected, please note work after re-connecting battery.
‹› When working on the selector mechanism in the engine compartment, remove the complete air filter housing, if it is located above the selector
mechanism
‹› To replace operating cables, remove shift mechanism --> [ Selector Mechanism ] See: Removal and Replacement/Selector Mechanism.