Jetta Sedan V6-2.8L (BDF) (2003)
/Page-1298005.png)
-
Clip in speed sensor wiring -arrows-.
Make sure the wiring is not twisted when installing the speed sensor wiring in the wheel housing.
-
Insert brake wear indicator connector into bracket on suspension strut.
-
Guide contacts into connector housing.
-
Push individual wiring seals in onto stop with an insertion tool from VAS 1978.
-
Secure contacts with secondary locking device and install multi-pin connector cover cap.
Checking Rotor Lateral Run-Out
Checking rotor lateral run-out
-
Raise vehicle.
-
Remove wheel.
