Jetta Sedan V6-2.8L (BDF) (2003)
^
3278 Funnel
Note: If a new installation tool (funnel) is used to install the pistons, first pass piston with oiled piston rings through the funnel twice and remove
the resulting metal shavings if necessary. Only then install piston with piston rings.
Work sequence
-
Push piston by hand into oiled installation tool (funnel). Flat side of piston crown must face toward tab on funnel -arrow-.
-
Hold installation tool (funnel) on upper edge and press piston in with both thumbs.
-
Push piston in until it protrudes approximately 15 mm from lower edge of tool (funnel).
-
Insert piston into appropriate cylinder bore. Tab on tool (funnel) -arrow- must face center of cylinder block.
-
Press installation tool (funnel) tightly against cylinder block and push piston in.