Jetta Sedan V6-2.8L (BDF) (2003)
Intake Manifold: Service and Repair
NOTE: For additional information regarding the Removal and Installation procedure please refer to: Vehicle /Engine, Cooling, and Exhaust /Engine /
Cylinder Head Assembly /Valve Cover / Service and Repair.
See: Cylinder Head Assembly/Valve Cover/Service and Repair
Intake Manifold, Disassembling and Assembling
1
-
Intake manifold.
-
For Removing and Installing procedures refer to: Vehicle /Engine, Cooling, and Exhaust /Engine /Intake Manifold/ Service and Repair.
See: Cylinder Head Assembly/Valve Cover/Service and Repair
2
-
Seal.
-
Always replace.
3
-
Bearing cap.
-
For Intake Manifold Change-Over Valve - N156 - barrel.
4
-
Bracket.
-
For engine cover mounting pin.
5
-
Mounting pin, 5 Nm.
-
For engine cover.
6
-
5 Nm.
7
-
23 Nm.
8
-
Vacuum union.
-
From brake booster.
9
-
Vacuum union.
-
From fuel system diagnosis pump.
10 -
Vacuum union.
-
From fuel pressure regulator junction piece.
11 -
Vacuum union.
-
From crankcase breather/Evaporative Emission (EVAP) Canister Purge Solenoid Valve 1 vacuum line junction piece.