Jetta Sedan V6-2.8L (BDF) (2003)
-
80 degrees C is in range B and corresponds to a resistance of 275 to 375 ohms
If the specification is not obtained:
-
Replace Mass Air Flow (MAF) sensor -G70-, item 6.
-
Check DTC memory, repair malfunctions if necessary and then erase DTC memory.
See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes
-
Read readiness code. If the DTC memory has been erased or the Motronic Engine Control Module (ECM) -J220- was disconnected from battery
positive (B+), the readiness code must be generated again.
See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If there is no Diagnostic Trouble Code (DTC) in the wiring and the resistance measurement values are OK.:
-
Replace Motronic Engine Control Module (ECM) -J220-.
-
Check DTC memory, repair malfunctions if necessary and then erase DTC memory.
See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes
-
Erase learned values and adapt Motronic Engine Control Module (ECM) -J220- again.
-
Read readiness code. If the DTC memory has been erased or the Motronic Engine Control Module (ECM) -J220- was disconnected from battery
positive (B+), the readiness code must be generated again.
See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes