Jetta Sedan V6-2.8L (BDF) (2003)
1
-
Passengers airbag unit with airbag igniter 1, Passengers side -N131-.
2
-
Connector
3
-
Central tube
4
-
Brace
-
Always replace after airbag has deployed.
5
-
Bolt
-
Qty. 4, 2.5 Nm
6
-
Bolt
-
Qty. 4, 2.5 Nm
Front Passengers Airbag Unit (Instrument Panel Without Airbag Seam), Removing and Installing
Front Passengers Airbag Unit (Instrument Panel Without Airbag Seam), Removing And Installing
Removing
CAUTION: Before working on electronic components, disconnect battery ground (GND) strap.
-
Disconnect battery Ground (GND) strap.
-
Remove center console.
-
Remove glove compartment.
CAUTION: Observe safety precautions for working on airbags.
-
Remove four bolts - 5 - (2.5 Nm).
-
Push out airbag unit - 1 - with two supports - 4 - upward out of angle brackets on central tube - 3 -.
-
Press airbag unit - 1 - aside and lower until harness connector - 2 - is accessible.
CAUTION: Electrostatic charges may result in involuntary deployment of airbag. Therefore, mechanic must be electrostatically
discharged before disconnecting ignition- and Ground (GND) wires. This is done e.g. by briefly grasping chassis or door striker.