Jetta Sedan V6-2.8L (BDF) (2003)
Wheel Speed Sensor: Service and Repair
ABS Mark 60
ABS System Components, Removing and Installing
ABS system on front axle, removing and installing
Note: Removing and installing ABS system parts is identical for FS 111 and EN 3 brake calipers.
1. ABS speed sensor
-
Before inserting sensor, clean mounting hole inner surface and coat with lubricating paste G 000 650
-
Checked by On Board Diagnostic (OBD)
2. Wheel bearing housing
3. Hex socket head bolt, 8 Nm (70 inch lbs.)
4. Splash plate
5. Hex bolt, 10 Nm (62 inch lbs.)
6. Wheel bearing
-
Replace each time after removing
-
Pressing out and in
7. Phillips-head screw
8. Brake disc
9. Wheel hub with rotor
-
Pressing out and in
10. Circlip
Speed Sensor, Removing and Installing
Speed sensor on front axle, removing and installing
Removing
-
Raise vehicle.