Jetta Sedan V6-2.8L (BDF) (2003)
^
VW 801 Holding plate
^
VAG1331 Torque wrench
^
1 - Kukko 21/7 Internal puller
^
4 - Kukko 22/1 Counter-support
It is only necessary to readjust the input shaft when the following components are replaced:
^
Transmission housing
^
Clutch housing
^
Input shaft
For the
^
Tapered roller bearings
Refer to Adjustments
^
Shims of determined thickness are installed for both output shafts.
^
Press tapered roller bearing outer race without shim into transmission housing onto stop.
^
Install both output shafts and input shaft in clutch housing and assemble transmission housing. Tighten hex head bolts to 25 Nm and then turn 45
° (1/8 turn) further.