Jetta SportWagen L4-2.0L Turbo (CCTA) (2009)
-
Install the plenum chamber bulkhead.
-
Install the wiper arms and plenum chamber cover.
-
If the ECM was replaced, connect the (VAS 5051B) and perform the "Guided Function, Replacing Engine Control Module ".
-
Check the ECM Diagnostic Trouble Code (DTC) memory erase all DTC entries. Refer to "Guided Function".
‹› If the DTC memory was erased, generate a readiness code.
-
Perform a test drive.
‹› Observe the safety precautions that apply to road tests. Refer to --> [ If special testing equipment is required during road test, note the following: ]
See: Fuel Delivery and Air Induction/Service Precautions/Vehicle Damage Warnings/Safety Precautions.
-
Again, check the ECM DTC memory.