Jetta SportWagen L4-2.0L Turbo (CCTA) (2009)
‹› When tightening, counter hold on hex head of joint bolt.
‹› Self locking.
‹› Always replace after removal.
2
Coupling rod
‹› Linking stabilizer bar to strut.
3
Bracket
‹› Locating, refer to--> [ Subframe Locating ] See: Procedures/Subframe Locating.
‹› If a bracket is replaced, the vehicle must be aligned. Refer to --> [ Wheel Alignment ] See: Alignment/Service and Repair/Wheel Alignment.
4
Mounting bracket
‹› Locating, refer to --> [ Securing the Mounting Bracket ] See: Procedures/Subframe Locating
‹› With bonded rubber bushings.
5
Bolt, 50 Nm + 90° additional turn
‹› Always replace after removal.
6
Bolt, 70 Nm + 90° additional turn
‹› M12 x 1.5 x 90.
‹› Always replace after removal.
7
Bolt, 70 Nm + 90° additional turn
‹› M12 x 1.5 x 90.
‹› Always replace after removal.
8
Front level control system sensor (G78)
‹› Can be tested in "Guided Fault Finding" using the (VAS 5051).
9
Bolt, 9 Nm
10
Control arm
‹› Description: Cast steel.
‹› Replace with ball joint if damaged.
‹› Removing and installing, refer to --> [ Control Arm with Mounting Bracket ] See: Control Arm/Service and Repair/Front Suspension/Control
Arm with Mounting Bracket.
‹› Replacing bushing, refer to --> [ Control Arm Bushing ] See: Control Arm/Control Arm Bushing/Service and Repair
11
Control arm
‹› Description: Steel plate.
‹› Replace with ball joint if damaged.
‹› Removing and installing, refer to --> [ Control Arm with Mounting Bracket ] See: Control Arm/Service and Repair/Front Suspension/Control
Arm with Mounting Bracket.
‹› Replacing bushing, refer to --> [ Control Arm Bushing ] See: Control Arm/Control Arm Bushing/Service and Repair.