Jetta SportWagen L4-2.0L Turbo (CCTA) (2009)
Transmission Position Switch/Sensor: Testing and Inspection
Diagnostic Procedures
Selector Lever Voltage Supply, Checking
Special tools, testers and auxiliary items required
‹› multimeter.
‹› Wiring diagram.
Test requirements
‹› The Direct Shift Gearbox (DSG) Mechatronic (J743) fuses OK.
‹› Battery voltage at least 12.5 volts.
‹› All electrical consumers such as, lights and rear window defroster, switched off.
‹› Selector lever in "P".
‹› A/C switched off.
‹› Ground (GND) connections between engine/transmission/chassis OK.
‹› Ignition switched off.
Test procedure
-
Perform a preliminary check to verify the customers complaint. Refer to --> [ Preliminary Check ] See: Computers and Control Systems/Testing
and Inspection/Scan Tool Testing and Procedures/Preliminary Check
Start diagnosis
-
Remove the selector mechanism, far enough to gain access to the Selector Lever (E313) electrical harness connector - A -.
-
Disconnect the Selector Lever (E313) electrical harness connector - A -.