Volkswagen Workshop Service and Repair Manuals

‹› Always replace after removal.

8

Bolt, 10 Nm

9

Vented brake disc

10

Bolt

‹› M16 x 1.5 x 80.

‹› Hex bolt = 200 Nm + 180° additional turn.

‹› 12 point bolt = 70 Nm + 90° additional turn.

‹› Always replace after removal.

Vehicle must not rest on its wheels when loosening and tightening.

11

Bolt

‹› Tightening specifications, refer to --> See: Brakes and Traction Control.

12

Wheel hub with wheel bearing

‹› Sensor ring for the Anti-lock Brake System (ABS) is installed in the wheel hub.

‹› Various versions.

13

Wheel bearing housing

‹› Removing and installing, refer to --> [ Wheel Bearing Housing ] See: Wheel Bearing Housing. 

‹› With bolted brake carrier.

‹› If the wheel bearing housing is replaced, vehicle alignment must be performed afterwards. Refer to --> [ Wheel Alignment ] See:

Maintenance/Alignment/Service and Repair/Wheel Alignment.

14

Wheel bearing housing

‹› Removing and installing, refer to --> [ Wheel Bearing Housing ] See: Wheel Bearing Housing. 

‹› With bolted brake carrier.

‹› If the wheel bearing housing is replaced, vehicle alignment must be performed afterwards. Refer to --> [ Wheel Alignment ] See:

Maintenance/Alignment/Service and Repair/Wheel Alignment.

15

Bolt, 70 Nm + 90° additional turn

‹› M12 x 1.5 x 45.

‹› Always replace after removal.

16

Drive axle

‹› Removing and installing, Refer to one of the following:

‹› --> [ Drive Axle, with CV Joints VL90, VL100 and VL107 Bolted to Intermediate

Shaft ] See: Axle Shaft Assembly/Service and Repair/Removal and Replacement/Drive Axle, with CV Joints VL90, VL100 and VL107 Bolted to
Intermediate Shaft

‹› --> [ Drive Axle, with CV Joint VL107 Installed on Stub Shaft ] See: Axle Shaft Assembly/Service and Repair/Removal and Replacement/Drive

Axle, with CV Joint VL107 Installed on Stub Shaft

‹› --> [ Drive Axle, with Triple Roller Joint AAR2600i ] See: Axle Shaft Assembly/Service and Repair/Removal and Replacement/Drive Axle, with

Triple Roller Joint AAR2600i